Because PogoCam is attached to your glasses most of the time, it communicates with you through a series of beeps and lights. PogoCam includes a "wallet card" to remind you of all these signals. The wallet card's reminders are reproduced below but here are two simple videos to demonstrate the LEDs of PogoCam.
The Buttons and Lights of PogoCam
The rear LED of PogoCam
Sounds
To do this |
Do this |
You’ll hear |
POWER ON |
Hold back button |
3 beeps. Wait for 2 more. Ready |
TAKE A PHOTO |
Press front button |
1 beep. Wait for 2nd beep. |
START A VIDEO |
Press back button |
2 slow beeps. |
STOP A VIDEO |
Press back button |
2 quick beeps. |
POWER OFF |
Hold back button |
1 beep followed by 4 quick beeps. |
Â
NOTE: If you do not take a photo or video for 90 seconds, you will hear 5 quick beeps to alert you that the camera is powering down.
Lights
When |
You’ll see |
POWERING ON |
Green light flashes slowly until 2 beeps tell you the camera is ready. Then the light will flash more quickly. |
TAKING PHOTO |
Red LED on the side will flash once. |
RECORDING VIDEO |
Red LED on the side will flash. |
MEMORY FULL |
Rapid flashing of Red LED. |
LOW BATTERY | Red LED is solid. |
Â
NOTE: PogoCam will continue to beep when you press the buttons even once the memory is full or battery low.
Comments
0 comments
Please sign in to leave a comment.