Note: PogoCam comes from the factory partially charged. You may need to fully charge the camera before using.
Before using the camera, you will also need to remove the protective film that covers PogoCam's lens. It has a blue tab on it.Â
Getting Started
Attach safety ring to the back of PogoCam using the smallest ring that easily slides onto your frames.
Â
Power
Press and hold the rear button to turn the camera on (3 beeps) and off (5 beeps).
Â
Capture
Press and release the front button (near the lens) to take a photo. Press and release the rear button to take a 30-second video (stop sooner by pressing the button again).
You'll hear one beep at the start and end of photo capture (be sure to keep still in between). And, two beeps at the start and end of video capture.
Charge & download
Place the camera on the USB connector inside the smart case as illustrated here.
Power on to charge and download
Close the case and power on. To power on, flip the switch next to the Bluetooth button from 0 to 1. Recharging will begin and images will automatically be moved off PogoCam and into the smart case storage.
Transferring
Use the USB cable included to download videos to your computer.
Attach PogoCam to glasses with PogoLoop
For a detailed explanation of attaching the PogoLoop adaptor, see this article.
There’s more here!
This guide has the basics to get you started, but you can find more product information, videos, and tips on our website.
Go back to the main support page.
Comments
0 comments
Please sign in to leave a comment.