Here is our quick guide to attaching PogoLoop to your glasses.
Identify the sides of the PogoLoop
Each PogoLoop has a metal side which faces outward where PogoCam attaches and a plastic side which faces the arm of your glasses.
Putting PogoLoop on your glasses
Pull the tab on the end of one loop to extend it to fit over the end of the temple.
Holding the PogoLoop with the metal side up, insert the end of the temple into the extended loop from the top down.
Slide the loop up the temple about 1/2 inch.
Pull the other tab to extend the opposite loop and wrap the loop around the end of the temple and slide the PogoLoop up the temple to its final position.
PogoLoop should be positioned with the metal side facing outward and aligned with the temple. If needed, PogoLoop can be tilted slightly upward or downward on the frame to change the camera angle.
The front of PogoCam should be aligned with the front of your glasses. When you remove the camera, you can leave PogoLoop attached to your glasses so its always ready for use.